Cut the wire to length (4 times around the item you are clamping plus 30cm of wire).
Fold wire in half and place grey cap on ends of wire.
Wrap the wire around the item you require to clamp, tuck the ends through the loop (as shown in image), do this twice.

Remove the grey wire cap. Place the tool in position as shown in Image 2.
Ensure the wire goes over the front small pins, then twist around the larger pins and link the wire together.
Twist these ends together securely.

Place notch on the tip of the Clamptite tool against the wire loop.
Hold it is place while you twist the wingnut clockwise to tighten.
As the wire tightens ensure the wire is correctly seated for a perfect clamp. 

Once desired tension has been reached Flip the tool over to lock the clamp in place.
Loosen the wingnut and remove the Clamptite tool.
Clip off ends of wire about 5mm for clamp and push them down against the hose to remove sharp edges.

Not all users master the Clamptite in the first use, however

and so helpful with so many uses around the Home, Boat, 4WD, Shed, Farm, Car, etc.

Adam used the ClampTite to hold a garden pot together after cutting it in half to replant and reuse pot, such a clean finish!
Great work Adam!

This pipe was run over accidentally and leaking, Tom was able to quickly cut and put an extender piece of pipe in and he didn't have the correct size pipe on hand or hose clamps, but was easily able to join the different sized pipes with the Clamptite.

Stainless Steel & Aluminum Construction

The Original Clamptite, The tool is great for any emergency and
tough wire jobs. 

Stainless Steel and Bronze Construction

Stronger Construction gives more torque and can be used with
higher gauge wire. 

The Clamptite is Made in the USA of premium quality materials, Stainless Steel, Brass & Aluminium. 

In its 60 years of manufacture the design has been refined and perfected.

Rest assured with our Lifetime Warranty covering component damage and Boat Hardware's Support & Returns Policy - We've got you covered!